How to Solve Linksys Velop Mesh Red Light Issue?

 Linksys brand provide a lot of the networking devices to the users. These devices are router configured via myrouter.local, smart WiFi configured by linksyssmartwifi.com, extender configured by extedner.linksys.com. There is Velop mesh system which is configured using linksyssmartwifi.com. Here, we will provide meaning one of the Linksys Velop light that is red color light, let’s see its meaning, reasons, and the solutions to fix the problem. .

Meaning:

If there is a red light on the Linksys Velop it means the device is not getting the internet connectivity. There can be technical reasons of this problem, and simple solutions to the solve it.

Reasons: Linksys Velop Mesh Red Light

1.       Velop router node can be disconnected from the modem network.

2.       Ethernet cable can be damaged or cut and not working fine.

3.       Firmware version is gone out of date hence Velop red light will appear.

4.       Linksys device or any other networking devices placed near to the electronic device.

Now, have a look at some troubleshooting tips and solutions to the fix this Linksys Velop red light issue.

Solutions: Linksys Velop Mesh Red Light

Check Velop Connection with Modem

One of the Velop devices connects to the modem with the help of the Ethernet cable, which will use to send and receive WiFi signals. So, it must be connected correctly in the right ports of both devices. The pattern for the connection is the modem LAN port and Velop router WAN port.

Check All Cable Conditions

The cables like Ethernet cable and the power cords are an important part of the Velop setup, so these cables must be in good condition. If you found any damaged or cut on the cables then replace them right away.

Choose Another Optimal Location

You have to choose an optimal location in your house far away from the electronic device like microwave ovens or microphones. This idea will help you to run/use the internet services without any interruptions.

Reboot Linksys Velop Device

If the all the above written tips or solutions are not helping or solving the problem, then you can reboot the Velop device with the help of the given steps;

1.       Find the power button and press it two times.

2.       Plug out and plug in Velop power adapter into the power wall outlet.

Reset Linksys Velop

If rebooting all the Linksys settings and networks is also not helping to find solutions, then hard reset the Linksys Velop mesh system by following some instructions;

1.       Find the reset button under the device.

2.       Press and hold it using the sharp object about 5-10 seconds.

3.       Your device will start to reset and after that you have to configure the device again.

Configure Again

 

1.       Connect computer to the Velop network via LAN cable or SSID.

2.       Open or launch the web browser and type the linksyssmartwifi.com, press the Enter button to search.

3.       You will get to the login page of the interface; here you have to enter the default username and password.

4.       By typing the username and password, and clicking on the Log In button, you will get to the interface dashboard.

5.       Here, you can re-configure any the settings and networks easily.

You can also use the Linksys app in your phone to re-organize the Linksys device settings and network. But you have to create an account by providing new Email ID, name, password and confirm password. Then you can access the Linksys app dashboard and configure any the settings and networks.

End Conclusion 

Here, you have seen and learned about meaning about the Linksys Velop red light color, reasons, and solutions.